Comments
-
@krs, Yes, it should be the second one - .microsoft.com Thanks!
-
Hello @Yuber_Sierra, This is an existing reported issue. Please reach out to SonicWall support for help. Thanks!
-
Hello @one4themoney, I am not seeing any such reported issues. Please make sure that Netflix is allowed under CFS and App control. We might need to do some real-time troubleshooting to figure out the root cause of the issue if it is allowed under both of those security services. Thanks!
-
@OY1, I would suggest using the aggressive mode for building the VPN as you have multiple WAN and internal IPs on the firewall. Kindly go through the KB below for more details: Thanks!
-
Hello @LandonOliver, This option is now moved to the diag page of the firewall in Gen 7. Kindly use https://<IP of firewall>/sonicui/7/m/mgmt/settings/diag to access the diag page. This option should be available under the 'ROUTING AND NETWORK SETTINGS' section. Thanks!
-
@Gustrastren, This is how the NAT should look like: Original source: 192.168.1.0/24 Translated source: 70.70.70.70 Original destination: Remote VPN network Translated destination: Original Original service: Any Translated service: Original Inbound interface: Any Outbound Interface: Any When creating the NAT manually, you…
-
Agreed. I will update the concerned team. Thanks!
-
@thethakuri, I would suggest upgrading to 6.5.4.7-83n as that is the latest general release and the most stable. You can directly upgrade to 6.5.4.7-83n. Thanks!
-
Hello @Enzino78 , Kindly enable 'Firewall Mode Switching' toggle switch from mysonicall.com first and then you should be able to find the button on the firewall GUI. Thanks!
-
@thethakuri , Yes, certainly. Kindly take a look at the below KB for all the steps. Thanks!
-
Anytime. You too have a good one.
-
@thethakuri, You can upgrade to the latest general release firmware 6.5.4.7-83n and test. But, I do not think this could be a hardware issue. You can reach out to SonicWall support for further investigation. Thanks!
-
@thethakuri, So basically the network probe is down due to which the firewall has probably removed this static route from its routing table. Is the probe set to something that is directly reachable from the firewall at all times? Can you disable the network probe just for testing and check if that solves this issue? Thanks!
-
@thethakuri, Is this happening for all networks that you have mentioned in the destination of the route or particularly for this one? Also, what exactly is connected on X6? Is there any network probe set on the static route? Thanks!
-
Hello @JimAllenSW, What firmware is the TZ 600 on? I could not find anything like this reported on my end. Thanks!